Sorry, you need to enable JavaScript to visit this website.

picozed can not establish TCP/IP connection with PC

Solved
2 posts / 0 new
sxdfyyp@163.com's picture
sxdfyyp@163.com
Junior(0)
picozed can not establish TCP/IP connection with PC

I have connect my PC and picozed through RJ45 connector, and set my PC and picozed in the same subnet. And PC 's IP is 192.168.3.1, the board is 192.168.3.2, there mask is 255.255.255.0. after that, I run the "ping 192.168.3.2"command in the dos window of PC, it can get response, but when i want to tansmit data from PC to board, the error occurred. it told me ,the hardware have no response. and I havd installed the add-on  apps or plugs in the matlab. and the most important thing is my PC can not connect with the internet or router.wish you solution.thanks!

DSP_1's picture
DSP_1
Moderator(1)
Re: picozed can not establish TCP/IP connection with PC
If you wish to perform radio-in-the-loop simulation from MATLAB/Simulink you must have installed Communications System Toolbox Support Package for Xilinx Zynq-Based Radio http://www.mathworks.com/help/supportpkg/xilinxzynqbasedradio/index.html
 
This is fully explained in this video: http://microzed.org/videos/qpsk-receiver-radio-loop
 
You can then configure and test communication between the host and PicoZed SDR from Guided Host-Radio Hardware Setup http://www.mathworks.com/help/supportpkg/xilinxzynqbasedradio/ug/guided-...